It’s the last post of the year! I just want to make a short note of thanks to everyone who as supported me and S&S during the last 6 months of tireless construction and blogging. 2015 has been a year of learning and new experiences and I can’t wait to see what 2016 has in store! Thank you everyone, Happy new year!!!
Ive been feeling crafty! I stumbled upon an awesome side table tutorial and decided to raid my wood pile and make my own! I made the one below for my bf for Christmas. Here’s how:
1. Aquire stump.
Any old stump will do.
2. You will have to allow the stump to dry out for about a month or so. Then the bark will be easy to remove and it will be significantly lighter. You can tell it is dry enough when you can see the bark separating, like below:
3. You will need a hammer and a chisel thingy.
Hammering the chisel thingy into where the bark and stump have begun to separate should make it easy to remove the bark. For me it peeled off without too much difficulty. It will take a little extra work around the knots, you will have to come at it at different angles with the chisel thingy, or use the prying end of the hammer.
4. It will look like this.
Sand the crap out of it.
Decide which end will be the top and sand that end as well. Try to get all the sharp or splintered edges, ends of the knots and all the little wood hairs off.
Use a variety of grits.
5. Wipe it down. Use a damp rag.
This will get all the dust from sanding off.
6. Put legs on! (Or don’t)
I used 3 inch “Capita” legs i found at IKEA. I also used longer screws than IKEA gave me due to the big heavy stump i was attaching to them.
A standard side table is about 25 inches tall. If you’re stump doesn’t need legs (or you dont want them, consider putting those little felt stickems on the bottom so the table doesn’t scratch your floor.)
7. Seal it.
I used this stuff.
I did 3 or 4 coats on the sides and 5 or 6 on the top, let it dry in between coats.